SAFETY VALVES /
THERMOCOUPLES
for Antique Stoves
Oven
Not
Operating ?
FREE Testing
AVAILABLE
FOR
YOUR Safety Valves,
Thermocouples or
Solenoids
for your vintage range -
New, Rebuilt or Used
If
oven does NOT TURN ON or
operate,
problem can be in several areas ... most economical solutions
below - no cutting or fitting!
Rebuild ! Click
to see MR-2 and Grayson
styles below...
Forget about having to re-plumb your
stove
or trying to find a generic replacement part!
High Quality Antique Safety Valves can be
Restored by Rebuilding
|
|
Introducing the NEW
San Marin TS-7
Safety Valve
First Safety Design Improvement
in Over 50 Years!
Super Sensitive
Heavy Duty
Magnetic Head
Contact JES Now at:
(805) 643-3532
toac@sbcglobal.net |
CHECK YOUR THERMOCOUPLE
An excellent
tool,
"The
CHECKER" will let you know if your thermocouple or safety valve is not operating
properly. Also used to check a thermostat thermocouple.
"The CHECKER"
Thermocouple - 'A'
Thermocouple Checker -
'b'
Just unscrew the threaded end (A) of the thermocouple from the safety valve
and into the checker (B).
Hold in for 1 minute. If end pops out the thermocouple is bad.
Requires no electricity or batteries - no meters to read or technical
knowledge necessary.
Can also be used to test thermocouples outside of stove with just a
lighter. Good for the life of your stove.
For
the first time since I bought the house, my oven is working beautifully...
...refurbished
for half the cost. My plumber re-installed the thermocouple and refurbished safety
valve..."
P.
Dautel - Texas
Last
February I bought a house that was built in 1950. It's a lovely house with red oak hard
wood floors, lots of windows, and a wonderful Universal gas stove in the
kitchen in excellent condition, except the oven didn't
work. A local plumber diagnosed the safety valve problem. J.E.S. responded quickly by email and I arranged for my plumber to disconnect
the thermocouple and safety valve so the parts could be mailed to J.E.S.
|
SAFETY VALVE REBUILD
GRAYSON TS-7 Returns!
Installs in Minutes.
No Need to Replumb.
Commonly known as the "Pickle
Valve" for its shape, the Grayson TS-7 can now be remanufactured to better than
original factory specifications.
All TS configurations
can be restored.
TS 7, 9, 11, 12,
13, 14 & 15
IMPORTANT NOTICE:
All Safety Valves carry a TWO-YEAR domestic warranty.
All units are heat and cold cycle tested for
maximum performance. Magnetic heads are serviced and re-magnetized if required.
Gaskets are replaced. Each unit is leak-proofed, casings are chem-bathed,
painted, shop tested and factory certified with two-year warranty.
Email pictures, front back and side, of
the valve.
We will reply if we have your exact antique model on the shelf
ready to ship!
Once all is working, send in your old core for exchange.
24 Hour turnaround on
all units in stock.
All major cards or
PayPal accepted.
|
Testimonials below...
FREE Testing
PROFESSIONAL TESTING
of
SAFETY
VALVES and THERMOCOUPLES
Let us know the
problem you are experiencing.
Then send in parts
for your
FREE TESTING.
After the parts
examination we will contact you for the quickest and most
economical remedy.
Expert
rebuild
services save your time and money.
KEEP
ORIGINAL VALVES
Highest Quality ever Made
Best
Fit for your
Antique Stove
Or, email pictures, front back and side, of
the valve. We will reply if we have your exact antique model on the shelf
ready to ship!
Once all is working, send in your old core for exchange.
24 Hour turnaround on
all units in stock.
Make sure you hire a licensed appliance tech
beforehand to
diagnose that your safety is actually the problem.
There is no return, refund or credit on
any safety valve, pilot assembly, minipilot or combination pilot ordered
except for
Two Year Guaranteed
Warranty Service.
Call 805-643-3532
or
e-mail
toac@sbcglobal.net
Get Your Stove
Up and
Running
HIGHEST QUALITY
FULL SERVICE ! |
|
New!
Forget about having to re-plumb your stove
or trying to find a generic replacement part
to replace the high quality safety valve in your stove.
Now
up to 98% of all MR-2 (General Controls) and Grayson
Thermostatic Safety Valves Can Be
Restored by Rebuilding.
Save
Your Precious Time and Money
Rebuilding is Better!
After all, after 40, 50 or 60 years! of
service these high quality valves could use a rebuild.
They were made to Keep Going and Going Strong!
For
preliminary examination
send a picture of your safety valve to toac@sbcglobal.net
or send in your old safety valve for a FREE
Bench test.
We
report back within 24 hours with test results by e-mail
(except
on holidays, weekends or during stock checks).
Remember,
the test is on us !
Phone (805) 643-3532
Email
toac@sbcglobal.net
'Bulldog' Thermocouples
Available...
email picture with the length you need -
24", 30", 36", 48", 60" or 72"
Heavy duty, extra sensitivity, longer lasting,
fully tested.
One Year Warranty...
Comes with Free Instructions for your stove.
|
Hello Jack Santoro and Everyone in The Old Appliance Club,
I'm happy to
report that our 1952 O'Keefe and Merritt stove is finally working - totally!
I installed the parts you shipped, did a bubble test and all seems well. Just wanted to give you guys a big American-Flag
salute for helping me get our stove up and running. My wife is so happy! Our stove is like
a new toy and it's our Christmas gift, too! My wife can't believe she got her X-Mas
present. Finally!
Have a
great holiday.
Thanks
again for your help
and 'a tip of the
old
Santoro fedora' to you
all.
R. Mellinger - Michigan J.E.S. did some diagnostics on the
safety valve and told me it could be refurbished for half the cost of a new safety valve.
My plumber reinstalled the thermocouple and refurbished safety valve. For the first time
since I bought the house, my oven is working beautifully. And just in time for the
Holidays!
P. Dautel - Texas
|